project 7: IBU Prototype Part (3)

IBU Prototype Part (3)

28th September 2010

1000-1200

On the second day, we went to the Bengkel and continue our work. We had to cut the PVC pipe into small piece and connect to the bamboo. There are a few process to make the connector of the bamboo and as shown as below

The PVC pipe was place in front of the bengkel.

We were cut the PVC pipe using the saw and machine.

The other group of people was doing the same step.
Then, we had to cut off some of the upper part of the pipe using the saw.

Still in the process.

After that, we wait for the uncle to make the curve of the pipe. It seems there are a lot of people are waiting there.

Unfortunately, the bengkel was close at 5 o'clock in the evening and the uncle told us to continue tomorrow.